November 8, 20241 yr As best I can tell my unraid server should be operating at gigabit speeds but it doesn't seem to be. Any recommendations / suggestions? Perhaps a new driver is needed? I don't know how to install a new network driver in Unraid though. Under Tools -> System Devices I have this line: IOMMU group 25: [14e4:1639] 0b:00.0 Ethernet controller: Broadcom Inc. and subsidiaries NetXtreme II BCM5709 Gigabit Ethernet (rev 20) [14e4:1639] 0b:00.1 Ethernet controller: Broadcom Inc. and subsidiaries NetXtreme II BCM5709 Gigabit Ethernet (rev 20) But on my dashboard my Interface widget shows: Interface Inbound: 188.3 Kbps Outbound: 5.3 Mbps bond0 eth0 eth1 lo General info Counters info Errors info Network traffic Mode of operation bond0 fault-tolerance (active-backup), mtu 1500 eth0 100 Mbps, full duplex, mtu 1500 eth1 interface down lo loopback The server connects to a SG500-28P 28-Port Gigabit PoE Stackable Managed Switch and it shows: Any suggestions are appreciated, thank you!
November 8, 20241 yr Community Expert Solution Gbit degrades to 100M if a signal pin is missing somewhere along the way. Check cables, ports, plugs on router, switches, computers.
November 9, 20241 yr Author 3 hours ago, trurl said: Gbit degrades to 100M if a signal pin is missing somewhere along the way. Check cables, ports, plugs on router, switches, computers. Tried a cable that I know for sure was cat6 and it now shows 1000 Mbps. Thanks!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.