Hello, I purchased a new PC from AVA Direct. It came with Windows installed. I put in my new Unraid USB key and booted to GUI. It says on the last line

```

"amdgpu 0000:0d:00.0: [drm: jpeg_v4_0_early_init [amdgpu]]] JPEG decode is enabled in VM Mode"

```

And it is just stuck there. I have a monitor plugged in and this is what I see on the display. I am looking on my network (wireless connection) and I see nothing. I have tried to open all the unmarked IP addresses in my network, and there is nothing labeled to indicate the Unraid device. This is also the same thing it displayed when I booted without GUI. 

 

There is something about SATA link down. Not sure what that is about. There are 10 slots for drives going through a SATA expansion. I forget how many drives I have in there, maybe 7?

 

I am booting an AMD AsRock motherboard.

 

Any tips? I was hoping when I boot to gui I would see the GUI.

 

I am attaching a video

 

 

of the boot sequence.

Try booting with a different flash drive using a stock install, no key needed, that will confirm if it's a config issue or not.

Thanks Jorge. I installed unraid on a different USB and the exact same thing happened.

here is my system profile

unraid-profile.pdf

You may need to blacklist the AMD driver.

 

 

Thanks SimonF. I am going to continue the conversation in that other thread. I also have an Asrock motherboard.