February 23, 20251 yr Hi Guys, Im moving in from my QNAP set up, every device here was used in my QNAP and I understand there are a few errors with the drives but they still work (for now). For some reason, my 12 TB Parity Drive will no longer attach. It shows up and I can view it in bios but it does not spin up. (SDO) This along with a PCIE NVME drives I plan to use do not show up, but they do work if I take it out and place it on my QNAP or my PC. There are other drives that are also plugged in but I cant see them in unRAID at all. Any Help will be welcomed, thanks you. windfish-diagnostics-20250222-1717.zip.crdownload
February 23, 20251 yr Community Expert Looks like you posted diagnostics before they finished downloading. Start the array and post new diagnostics.
February 23, 20251 yr Author Hi trurl. Thanks for taking your time to look at this, that is weird I'll post them again, I just downloaded these from the device. windfish-diagnostics-20250222-1928 (1).zip
February 23, 20251 yr Community Expert Check/replace cables for disk1, then post new diags after array start.
February 23, 20251 yr Author Hi Jorge, I have replaced the wiriring for Disk1 bypassing the SAS Controller and connected directly to the board with a SATA Cable. windfish-diagnostics-20250223-0939.zip
February 24, 20251 yr Community Expert No disk error so far, but the HBA reset: Feb 23 09:38:10 Windfish kernel: mpt3sas_cm0 fault info from func: mpt3sas_base_make_ioc_ready Feb 23 09:38:10 Windfish kernel: mpt3sas_cm0: fault_state(0x2810)! Feb 23 09:38:10 Windfish kernel: mpt3sas_cm0: sending diag reset !! Feb 23 09:38:12 Windfish kernel: mpt3sas_cm0: diag reset: SUCCESS Possibly related, it's also complaining of overheating: Feb 23 09:36:10 Windfish kernel: mpt3sas_cm0: Temperature Threshold flags 0 exceeded for Sensor: 0 !!! Feb 23 09:36:10 Windfish kernel: mpt3sas_cm0: Current Temp In Celsius: 109 Feb 23 09:37:10 Windfish kernel: mpt3sas_cm1: Temperature Threshold flags 0 exceeded for Sensor: 0 !!! Feb 23 09:37:10 Windfish kernel: mpt3sas_cm1: Current Temp In Celsius: 106 Feb 23 09:37:10 Windfish kernel: mpt3sas_cm0: Temperature Threshold flags 0 exceeded for Sensor: 0 !!! Feb 23 09:37:10 Windfish kernel: mpt3sas_cm0: Current Temp In Celsius: 109 Feb 23 09:38:10 Windfish kernel: mpt3sas_cm1: Temperature Threshold flags 0 exceeded for Sensor: 0 !!! Feb 23 09:38:10 Windfish kernel: mpt3sas_cm1: Current Temp In Celsius: 106 Feb 23 09:38:10 Windfish kernel: mpt3sas_cm0: Temperature Threshold flags 0 3 exceeded for Sensor: 0 !!! Feb 23 09:38:10 Windfish kernel: mpt3sas_cm0: Current Temp In Celsius: 111
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.