I am receiving regular messages about one of my drives showing ata4 needing to be reset.

I cannot find anywhere how to identify which drive this is since ata doesn't seem to appear anywhere in the tools.

Thanks in anticipation.

Please post the diagnostics.

Thank you.

Here they are.

unraid-7.1.4.txt domain.cfg cache.cfg tempo.cfg docker.cfg editor.cfg super.dat network-rules.cfg ident.cfg network.cfg go.txt favorites.cfg disk.cfg listen.txt Sabrent_0546079B11F300654799-2025-06-04 tempo (nvme0).txt HGST_HUH728080ALE604_VKJBD9DX-2025-06-04 disk1 (sdd).txt SPCC_Solid_State_Disk_MP49W23228263-2025-06-04 cache (sdb).txt nvme.1987-3035343630373942313146333030363534373939-53616272656e74-00000001-2025-06-04 tempo (nvme0).txt USB_SanDisk_3.2Gen1_01010d3b4049c090dcd29f7efc6aadea0679845b44f2cfd07c4d76513779a9ddfdc500000000000000000000438651ecff81420083558107c82e1294-0-0-2025-06-04 flash (sda).txt TOSHIBA_MG08ADA800E_X3N0A30KFCXH-2025-06-04 disk2 (sde).txt HGST_HUH728080ALE604_VKJWP1MX-2025-06-04 parity (sdc).txt cmdline.txt btrfs-usage.txt drm.txt plugins.txt motherboard.txt iommu_groups.txt ntp.txt aspm-status.txt ethtool.txt folders.txt sshd.txt lsmod.txt lsscsi.txt loads.txt testparm.txt memory.txt lspci.txt meminfo.txt lsusb.txt urls.txt top.txt servers.conf.txt vars.txt lscpu.txt lsof.txt df.txt ifconfig.txt dhcplog.txt graphql-api.txt syslog-previous.txt syslog.txt appdata.cfg m---a.cfg a------p.cfg j---y.cfg system.cfg o------f.cfg shareDisks.txt tm.cfg b----p.cfg

Diags are generated as a single zip file, next time please post that.

ata 4 is this drive:

[4:0:0:0] disk ATA HGST HUH728080AL WDA0 /dev/sdd /dev/sg3

state=running queue_depth=32 scsi_level=6 type=0 device_blocked=0 timeout=30

dir: /sys/bus/scsi/devices/4:0:0:0 [/sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/ata4/host4/target4:0:0/4:0:0:0]

If you need to find out in the future, check lsscsi on the diags.

Thank you so much.

I've been puzzling over this for ages.

As for the diagnostics, I uploaded exactly what appeared in my downloads folder.

I wondered if I had done something to alter the output, so I just ran it again with the same result.

Whilst the program clearly displayed that it intended to download a ,zip, that's not what I ended up with.

Perhaps my Mac is becoming too smart.

I don't use a Mac, but I believe thy may automaticalli unzip the files to "try" and help.

Yes, it appears you are correct.

Safari has an option to open files after download. That's news to me.

I don't recall this happening before so it may have been set active in OS Sequoia which I recently installed.