Hello,

I suspect a power cable is having an issue. But a drive was disabled and I saw errors in rear or write (2048 errors). I couldn't figure what were the specific errors. Diagnostics attached. All help is appreciated. maxraid-diagnostics-20250911-1532.zip

Looks more like a power/connection issue; check replace/cables, and if the emulated disk is still mounting and contents look correct, rebuild on top.

P.S: there appears to be a container constantly restarting; see if you can find out which by looking at their uptimes and resolve that.

Thank you for confirming, I also ran an extended smart test and it came out with no errors.

if the emulated disk is still mounting and contents look correct, rebuild on top.

How do I do this? Stop the Array, Unassign drive, start the array, stop the array again and re assign the drive to the same slot and rebuild? Will it actually rebuild entirely or read and skip whats already there?

Thank you

Edited September 13, 2025Sep 13 by i_max

10 hours ago, i_max said:

Stop the Array, Unassign drive, start the array, stop the array again and re assign the drive to the same slot and rebuild?

Yes.

10 hours ago, i_max said:

Will it actually rebuild entirely or read and skip whats already there?

Unraid always does a full rebuild.

Thank you. Its underway. One more thing where in the diagnostics did you look to find the issue, I was trying to go through the diagnostics as well.

15 hours ago, i_max said:

One more thing where in the diagnostics did you look to find the issue

Mostly the syslog