June 9Jun 9 Hello Folks, I upgraded from 7.2.4 to 7.3.1 and my frigate does not connect to the custom network (br2.11). My cameras are on the same network (VLAN11) and it's not connecting to them. I have macvlan enabled. After upgrade, I tried switching to ipvlan and enabling Host access to custom networks. AI suggested that I run the command modprobe br_netfilter in terminal but that did nothing too. I rolled back to 7.2.4 and everything works fine. Any suggestions would be appreciated. I have attached the diagnostics that I got unraid-diagnostics-20260609-1103.zipafter I upgraded to 7.3.1 Edited June 9Jun 9 by Xxharry typo
June 9Jun 9 Did you try disable bridge, I upgrade to 7.3.1 with macvlan and not enable host access. All IOT device haven't problem to connect their vlan eth0.xx to docker. Edited June 9Jun 9 by Vr2Io
June 9Jun 9 Author 2 minutes ago, Vr2Io said:Do you try disable bridge, I upgrade to 7.3.1 with macvlan and not enable host access. All IOT device haven't problem to connect their vlan to docker.if I disable bridge, what will happen to my br2.11 network? I need it to route traffic for vlan11.
June 9Jun 9 6 hours ago, Xxharry said:if I disable bridge, what will happen to my br2.11 network? I need it to route traffic for vlan11.Then no br2.11 and replace with eth2.11
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.