My usb seemed to partially fail.

I had no backup and couldn't create one. I copied the contents of that usb to my pc.

I created a new usb which is now booting properly. Before the first boot I copied the contents of the config folder from the original usb to the new usb. It has booted up , I logged in using my previous credentials but now I am on a page to configure settings. Name etc.

I thought that it would just boot as the previous did. With the allocations already setup as well as all my docker stuff.

I am nervous that I procees I will lose all my previous setup.

.can anyone advise on how to proceed forward. I do have a screenshot of the previous drive allocations of needed

Thank you

1 hour ago, TYphoMeN said:

My usb seemed to partially fail.

I had no backup and couldn't create one. I copied the contents of that usb to my pc.

I created a new usb which is now booting properly. Before the first boot I copied the contents of the config folder from the original usb to the new usb. It has booted up , I logged in using my previous credentials but now I am on a page to configure settings. Name etc.

I thought that it would just boot as the previous did. With the allocations already setup as well as all my docker stuff.

I am nervous that I procees I will lose all my previous setup.

.can anyone advise on how to proceed forward. I do have a screenshot of the previous drive allocations of needed

Thank you

Just hit "skip onboarding" at the bottom

Onboarding wizard won't change any settings for the array or exiting pools, but you can just skip it as mentioned.