Hi

Im getting some errors on disk 5. Installed the paritydrive yesterday, synced it and run paritycheck.

That drive is the only drive that is connected to the 2port sata card (parity +1-4 is on the motherboard)

Should i be worried?

All drives exept 1+2 was precleard with no fault.

Can it be sata cable or powercable?

 

https://dl.dropbox.com/u/5314933/errors%20paritycheck2.png

Post a SMART report for disk5. Attach a syslog.

Starting google.com

Searching for...

"create syslog +unraid"

"Post a SMART report for disk +unraid"

DONE =)

smart.txt

syslog.txt

The disk need to be rebuilt to fix unreadable (pending) sectors. After the disk is rebuilt the pending sectors RAW value should be zero. If you have a spare pre-cleared drive use it now and pre-clear the faulty drive. Pre-clear, possibly repeatedly until the pending sector RAW value goes to zero. If the disk self-assessment is PASSED then the disk becomes the new spare. Otherwise the disk can be rebuilt in place.

To rebuild in place:

 

Stop the array and un-assign the disk.

Start the array.

Stop the array.

Assign the disk.

Start the array.

Click Rebuild.

 

After this procedure completes the pending sectors should be zero.

Thanks for the quick answers =) Love this forum =)

I dont hade a spare drive but i if i read right i just have to do the steps you discibed in the list?  i dont have to preclear the drive im using again?

Rebuilding the drive now.

Can i verify that the disk is ok when the rebuild is done?

Mayby do a paritycheck and if i dont se any errors everything is ok?

 

puh unraid isnt for everyone that needs a nas =P

After the rebuild is complete check the SAMRT report. Self-assessment status must be PASSED and Current_Pending_Sector RAW_VALUE must be zero.

smartctl  -a  -d  ata  /dev/sda | todos >/boot/smart.txt

Gave me a new smart status file. Looking good as far as i can se. Ill attach the new file so you can double check.

smart.txt

Looks good.