December 17, 201213 yr Hello Unraid Forum ! This is my first post in this Board ! I'm reading here for quite a long time now and get ALL the input I needed to build my rig without asking a single question. That is something near to amazing, you guys do a great job ! But now I will go on to my Problem: My Unraid Server: Xeon 1220lv2 Supermicro x9scm-f-o 8 gig Kingston ECC kit 16 gig Kingston flash for unraid 9 x WD30EFRX (WD RED 3TB) 8 Data Drives and of course the Parity drive ! latest unraid 5.0-rc8a AiO I will show you my Problem with this: This is my old Server moving Data from its VERY speedy Raid 5 over to the unraid box using robocopy. The Speed is hanging around 25% = 250Mbit/s = ~30Mbyte/s I dont use any cache drive, right, but It really should go higher right ? Is there anything else to think about if you guys see this config in general ? This is my first build and I do not want to fall over something like "you have to update your drives/controller firmware first !" so please give me some input Best regards from Germany ! Christoph
December 17, 201213 yr 30Mbytes/s seems like a reasonable speed. I typically get between 28-33Mbytes/s, with short bursts of up to 40Mbytes/s.
December 18, 201213 yr Author thank you cassiusdrow, thats very good input I will post my speed again with an cache drive attached when I get it ! best regards Christoph
Archived
This topic is now archived and is closed to further replies.