January 17, 200917 yr Hey guys...im about to upgrade to 4.4.2, and since its been out for awhile now...is there anything i should look out for when upgrading?....i only really have 1 user share, not user level security, just the basics. Thanks....currently im at 4.3.3....is it true 4.4.2 has the ability to spin u/down individual disks?
January 17, 200917 yr Hey guys...im about to upgrade to 4.4.2, and since its been out for awhile now...is there anything i should look out for when upgrading?....i only really have 1 user share, not user level security, just the basics. Taken from from the first post in the 4.4.2 announcement thread (and every other thread whereby a new version is announced)... it's a good place to go through a see what features are new. Upgrade Instructions (Please Read Carefully) ============================================ If you are currently running unRAID Server 4.2-beta1 or higher (including 4.2.x 'final'), please copy the following files from the new release to the root of your Flash device: bzimage bzroot If you are currently running unRAID server 4.0 or 4.1, please copy the following files from the new release to the root of your Flash device: bzimage bzroot syslinux.cfg menu.c32 memtest This can be done either by plugging the Flash into your PC or, by copying the files to the 'flash' share on your running server. The server must then be rebooted. If you are currently running unRAID Server 3.0-beta1 or higher, please follow these steps to upgrade: 1. Referring to the System Management Utility 'Main' page, make a note of each disks's model/serial number; you will need this information later. 2. Shut down your server, remove the Flash and plug it into your PC. 3. Right-click your Flash device listed under My Computer and select Properties. Make sure the volume label is set to "UNRAID" (without the quotes) and click OK. You do NOT need to format the Flash. 4. Copy the files from the new release to the root of your Flash device. 5. Right-click your Flash device listed under My Computer and select Eject. Remove the Flash, install in your server and power-up. 6. After your server has booted up, the System Management Utility 'Main' page will probably show no devices; this is OK, navigate to the 'Devices' page. Using the model/serial number information gathered in step 1, assign each of your hard drives to the correct disk slot. 7. Go back to the 'Main' page and your devices should appear correctly. You may now Start the array. If you are installing this release to a new Flash, please refer to instructions on our website at: http://www.lime-technology.com/wordpress/?page_id=19 [/code] Cheers, Matt
Archived
This topic is now archived and is closed to further replies.