Could UDMA_CRC_Error_Count  cause the red ball? is this where cable could be the problem? does the drive look okay to add back to the array?

 

Before the test there was 1 current_pending_sector

 

ID# ATTRIBUTE_NAME          FLAG    VALUE WORST THRESH TYPE      UPDATED  WHEN_FAILED RAW_VALUE

  1 Raw_Read_Error_Rate    0x002f  200  200  051    Pre-fail  Always      -      1

  3 Spin_Up_Time            0x0027  176  152  021    Pre-fail  Always      -      8183

  4 Start_Stop_Count        0x0032  097  097  000    Old_age  Always      -      3284

  5 Reallocated_Sector_Ct  0x0033  200  200  140    Pre-fail  Always      -      0

  7 Seek_Error_Rate        0x002e  100  253  000    Old_age  Always      -      0

  9 Power_On_Hours          0x0032  080  080  000    Old_age  Always      -      14785

10 Spin_Retry_Count        0x0032  100  100  000    Old_age  Always      -      0

11 Calibration_Retry_Count 0x0032  100  253  000    Old_age  Always      -      0

12 Power_Cycle_Count      0x0032  100  100  000    Old_age  Always      -      42

192 Power-Off_Retract_Count 0x0032  200  200  000    Old_age  Always      -      27

193 Load_Cycle_Count        0x0032  187  187  000    Old_age  Always      -      40146

194 Temperature_Celsius    0x0022  121  109  000    Old_age  Always      -      31

196 Reallocated_Event_Count 0x0032  200  200  000    Old_age  Always      -      0

197 Current_Pending_Sector  0x0032  200  200  000    Old_age  Always      -      0

198 Offline_Uncorrectable  0x0030  200  200  000    Old_age  Offline      -      0

199 UDMA_CRC_Error_Count    0x0032  200  200  000    Old_age  Always      -      6

200 Multi_Zone_Error_Rate  0x0008  200  200  000    Old_age  Offline      -      1

 

 

==  WDC WD30EZRX-00MMMB0    WD-WCAWZ1857328

== Disk /dev/sdf has been successfully precleared

== with a starting sector of 1

== Ran 1 cycle

==

== Using :Read block size = 8225280 Bytes

== Last Cycle's Pre Read Time  : 9:42:49 (85 MB/s)

== Last Cycle's Zeroing time  : 8:28:48 (98 MB/s)

== Last Cycle's Post Read Time : 24:06:49 (34 MB/s)

== Last Cycle's Total Time    : 42:19:33

==

== Total Elapsed Time 42:19:33

==

== Disk Start Temperature: 22C

==

== Current Disk Temperature: 31C,

==

============================================================================

** Changed attributes in files: /tmp/smart_start_sdf  /tmp/smart_finish_sdf

                ATTRIBUTE  NEW_VAL OLD_VAL FAILURE_THRESHOLD STATUS      RAW_VALUE

            Spin_Up_Time =  176    155          21        ok          8183

          Seek_Error_Rate =  100    200            0        ok          0

      Temperature_Celsius =  121    129            0        ok          31

No SMART attributes are FAILING_NOW

 

1 sector was pending re-allocation before the start of the preclear.

1 sector was pending re-allocation after pre-read in cycle 1 of 1.

0 sectors were pending re-allocation after zero of disk in cycle 1 of 1.

0 sectors are pending re-allocation at the end of the preclear,

    a change of -1 in the number of sectors pending re-allocation.

0 sectors had been re-allocated before the start of the preclear.

0 sectors are re-allocated at the end of the preclear,

    the number of sectors re-allocated did not change.

============================================================================

Looks OK.