June 8, 201412 yr Hi there, I have a huge problem. I gotten a new Virgin Media Superhub 2, together with a complete Gigabit Network throughout the house. All is connected to a TP Link TL-SG3424 gigabit managed switch. Before I gotten the the superhub 2 everything was working with copying files over to the Unraid server, but since I have installed the superhub 2 it stops. The superhub already has the newest firmware, yesterday i installed the newest firmware to the tp link switch, however that did not make a difference. I even upgraded my Windows 7 to Windows 8.1 just in case that could have caused an issue. I am at my wits end. I will need to use the superhub 2 so that I cannot really change. Any suggestions how I can troubleshoot this. I looked in the syslog and I cannot see anything around the time when the error occurs. The error I am getting is 0x8007003b unexpected network error occurs. Any suggestions are greatly appreciated. MrLondon
June 8, 201412 yr How do you have the Superhub configured? I have mine set up so that it acts purely as a modem (ignoring it ability act as a hub/router) and then connect the hub to the upstream side of my Netgear router. That means my home network is not even aware of the superhub. Since you say everything works fine on your TP Link switch I would have thought you could do the same?
June 9, 201412 yr Author actually it might not be the network after all, I have now connected a USB 3 key with data to the Server direct and copied a file which also failed during network copying and it suddenly takes a extremely long time to copy a 600mb file from NTFS usb to the share. I completes but it took about 15min, which is very slow... is there any way to check why that is happening? I don't see any error messages in the logs. syslog.zip
Archived
This topic is now archived and is closed to further replies.