February 4, 201511 yr Hello, I have two Unraid servers I have run for about 4 years. I just upgraded the motherboard and cpu on one of them. I installed an Asrock H97m pro4. I went through the bios and set everything up. I was able to connect to the internet to check the motherboard firmware, but I cannot telnet to the server or connect through the web gui on my network. I am using the onboard LAN it is an Intel 1218V. I am using the same usb stick, etc and the Unraid software seems to start up just fine. I run it headless but connected a keyboard and monitor to check it and configure the BIOS. I know this isn't much information but are there any ideas? Thank you
February 4, 201511 yr Author ifconfig Link encap:localloopback inet addr 127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:65536 Metric:1 RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 frame:0 collisions:0 txqueuelen:0 RX bytes:560 (560.0 B) TX bytes: (560.0 B) ethtool eth0 Settings for eth0 Cannot get device settings: no such device cannot get wake on lan settings: no such device cannot get message level: no such device cannot get link status: no such device no data available
February 4, 201511 yr I'd say that it looks like the driver for the 1218V isn't included in stock unRaid. You can either pick up a a cheap add-in card, or ask Tom / the forum for help in getting the driver in there. Or try installing 6.0 and see if the driver is there.
February 4, 201511 yr Author interesting. I have seen a couple other builds on here using the same board...... just rechecked, looks as if the other builds are using 6 betas. I'm on 5. maybe I will install the 6.
Archived
This topic is now archived and is closed to further replies.