Alexandro Posted February 7, 2015 Share Posted February 7, 2015 All, I upgraded an old data drive (750gb) with 1,5 years old 3 tb drive. The preclear of the 3 tb drive went unusually slow compared to all my other drives precleared in the past but with no errors. The rebuild took 3 days to complete. The next day the same disk gave a red ball status and the smart report says there is 1 pending sector. As the drive is still in warranty there is no problem to be replaced but meanwhile I would like to set my previous config with the old 750 gb hdd in service. I did backup the whole boot folder from the flash. Which files needs to be copied back to the config folder? Thanks. Quote Link to comment
trurl Posted February 7, 2015 Share Posted February 7, 2015 super.dat is the file with your array configuration, but I think you would be better to do a New Config since your parity probably doesn't match the old configuration anymore. Quote Link to comment
Alexandro Posted February 8, 2015 Author Share Posted February 8, 2015 Dear Trurl, Thank you for your answer. So the procedure should be as follows: 1. Restore super.dat in config folder. 2. Restart the unraid server. 3. "New configuration" button press. 4. Assign the drives to its original places 5. Start the unraid server. 6. The unraid will start to build a new parity. Thanks again. I am a bit scared of losing data. Quote Link to comment
trurl Posted February 8, 2015 Share Posted February 8, 2015 Forget about super.dat. New Config will wipe it out anyway. When you start with the old drive unRAID will say it's the wrong disk and will not start the array. Then you can do New Config and assign all drives. Then start and unRAID will rebuild parity. Just make sure you don't accidentally assign a data disk to the parity slot or it will get overwritten with parity. Quote Link to comment
Alexandro Posted February 8, 2015 Author Share Posted February 8, 2015 Thank you. Will try now. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.