Hey,

 

I just upgraded my Unraid from the November release to the latest - 14b.

 

I can access unmenu fine but the main webui which is essential to me for rebooting etc can not be accessed. I went to stop the raid in unmenu but that seemed to crash everything so I cut the power, the same problem when i turned it on again.

 

I followed the guide for upgrading by overwriting the  files - however I didn't have a "xen" file in my flash previously if that means anything

 

My syslog was too big to attach so I posted it here

http://pastebin.com/da4Hnhez

 

Thanks very much,

 

Regards,

 

 

first thing i see is you have some 32bit packages installing.  unraid 6 is 64 bit only

 

Mar 10 16:21:54 Tower logger: Package python-2.6.6-i486-1.txz installed.

Mar 10 16:21:55 Tower logger: Package zlib-1.2.5-i486-4.txz installed.

Mar 10 16:21:57 Tower logger: Package sqlite-3.7.5-i486-1.txz installed.

Mar 10 16:21:59 Tower logger: Package curl-7.21.4-i486-1.txz installed.

Mar 10 16:22:01 Tower logger: Package git-1.7.4.4-i486-1.txz installed.

 

 

Update ALL your plugins to use the 64 bit plugins

 

Scott

Better still would be to remove all plugins or boot in SAFE mode.

 

Also, zip and attach your syslog next time.

Thank you guys,

 

I will try and do a fresh install of unraid on my flash and only add the essential files - like my key etc.

Would that be just my config folder minus any packages?

I went to stop the raid in unmenu and it crashed again - turned it off during a parity check- hope I didnt damage anything

Everything is going good now - i formatted my flash and just put a few files like my network, 'super.dat', shares and everything is looking good, I have the new webui and unmenu too.

I have been using unraid 3 years and installed most updates - my 'programs' went from packages to plugins etc and I had lots of unnecessary stuff that wasn't been used. Anyways, everything is going good - just want to get 3 apps working now and im happy