June 30, 201511 yr Hey guys I was having problems trying to rsync with SSH to my remote server and I just decided to upgrade to 6.0. Anyway I followed the directions but obviously missed something because none of my drives were assigned. fortunately I read the directions and heeded them and made a screen capture of all the drives and their locations. I am in the midst of a parity sync now however my problem is that none of my shares exist?!. I did copy the config/shares folder from my 5.0 install. Can I safely restore these shares? Please advise. I hope I am not compromising data without them in place? Thanks! Neil
June 30, 201511 yr Community Expert Hey guys I was having problems trying to rsync with SSH to my remote server and I just decided to upgrade to 6.0. Anyway I followed the directions but obviously missed something because none of my drives were assigned. fortunately I read the directions and heeded them and made a screen capture of all the drives and their locations. I am in the midst of a parity sync now however my problem is that none of my shares exist?!. I did copy the config/shares folder from my 5.0 install. Can I safely restore these shares? Please advise. I hope I am not compromising data without them in place? My guess is that the User Shares are not enabled under Settings->Global Share Settings
June 30, 201511 yr Author Yes it is set to No. I have to wait for the parity sync to complete which is like 21 hours away. I will enable it and it should be all good correct? Thanks! Neil
June 30, 201511 yr Community Expert Yes it is set to No. I have to wait for the parity sync to complete which is like 21 hours away. I will enable it and it should be all good correct? I would expect that to be the case. I think you need to stop/start the array before that setting can be changed (or at least before it takes effect).
June 30, 201511 yr Yes it is set to No. I have to wait for the parity sync to complete which is like 21 hours away. I will enable it and it should be all good correct? I would expect that to be the case. I think you need to stop/start the array before that setting can be changed (or at least before it takes effect). In v6 these settings can only be changed when the array is stopped.
June 30, 201511 yr Author I should be safe to let the parity check complete - stop and enable the shares and get everything "back"? Thanks, Neil
Archived
This topic is now archived and is closed to further replies.