July 14, 201510 yr I installed the plex docker, which was very easy compared to what I was expecting and after a few hiccups (having to revers tunnel to get in for initial setup) everything seemed to be running fine. The next day I get home and I go to login to the GUI and I get a 404... I end up reinstalling and everything is fine. The next day 404 again, so this time I restart the docker and everything comes back. The next day, I try to login 404..... I restart the docker, this time it comes back in an initial setup state.... I'm using the default repository that came with 6.0.1 that already has plex media server on it and the server stays on over night. Plex is installed on a cache drive under /mnt/cache/appdata/plexmediaserver/. It runs fine when its working, lets me transcode, stream, and sync. Any suggestions would be appreciated. If more information is needed let me know..
July 14, 201510 yr I installed the plex docker, which was very easy compared to what I was expecting and after a few hiccups (having to revers tunnel to get in for initial setup) everything seemed to be running fine. The next day I get home and I go to login to the GUI and I get a 404... I end up reinstalling and everything is fine. The next day 404 again, so this time I restart the docker and everything comes back. The next day, I try to login 404..... I restart the docker, this time it comes back in an initial setup state.... I'm using the default repository that came with 6.0.1 that already has plex media server on it and the server stays on over night. Plex is installed on a cache drive under /mnt/cache/appdata/plexmediaserver/. It runs fine when its working, lets me transcode, stream, and sync. Any suggestions would be appreciated. If more information is needed let me know.. You must set your appdata user share to Use cache disk: Only or mover will move it to the array. Most likely that has already happened and you will need to clean it up from the other disks.
July 14, 201510 yr Author Duhhh Thanks! I'll rebuild the docker, is it safe to assume if I kick off the mover manually and everything is fine that it could have fixed the problem as long as that was actually the problem? Won't know for sure until tomorrow
July 14, 201510 yr If you didn't have it set to cache-only then it definitely got moved. It is easy to see this happening in your syslog. Look on each of your array disks and delete any appdata folders you find.
Archived
This topic is now archived and is closed to further replies.