I ran preclear twice and am getting some values on the SMART report that I do not know what to do with. This is a brand new drive, from an external enclosure. Any suggestions?

 

** Changed attributes in files: /tmp/smart_start_sdj  /tmp/smart_finish_sdj

                ATTRIBUTE  NEW_VAL OLD_VAL FAILURE_THRESHOLD STATUS      RAW_VALUE

      Raw_Read_Error_Rate =  117    114            6        ok                                  121260256

          Seek_Error_Rate =        60    100          30        ok                                      1101563

        Spin_Retry_Count =      100    100          97        near_thresh                      0

        End-to-End_Error =      100    100          99        near_thresh                        0

  Airflow_Temperature_Cel =    70      72          45        near_thresh                        30

      Temperature_Celsius =      30      28            0        ok                                      30

No SMART attributes are FAILING_NOW

0 sectors were pending re-allocation before the start of the preclear.

0 sectors were pending re-allocation after pre-read in cycle 1 of 1.

0 sectors were pending re-allocation after zero of disk in cycle 1 of 1.

0 sectors are pending re-allocation at the end of the preclear,

    the number of sectors pending re-allocation did not change.

0 sectors had been re-allocated before the start of the preclear.

0 sectors are re-allocated at the end of the preclear,

    the number of sectors re-allocated did not change.

 

Thanks,

 

Lev

Cleared.txt

tower-smart-20150928-1957.zip

That is the report of the changed values (before preclear to after preclear).  None of the values listed are an issue.  The drive is fine.

Great! Thank you very much.

 

Lev