February 7, 201610 yr I've been running v5.0.5 for the last few years without any major problems. I've successfully upgraded from v5.0.5 to v6.1.7 and everything seems to be working fine until I try to enable Docker. I marked enable to 'yes' and chose to create a 10GB image on the root of my cache drive. When I click apply, I get the 'creating docker image' message in the lower left of the page, but the webgui becomes unresponsive. My syslog (attached) shows a series of DMAR faults that start at the same time and repeat continuously. I've gone back to 5.0.5 and retried the upgrade several times and I always get the same result as soon as I try creating the first docker image. So for now I'm back on 5.0.5 but really want to upgrade and take advantage of docker and VMs. Any ideas? syslog.zip
February 7, 201610 yr You've got a metric ton of errors in the syslog. You really should post your full diagnostics next time you upgrade to v6, but initially I'd guess a hard drive cabling issue with sda
February 7, 201610 yr Author I'm sure I'll get restless and try the upgrade again tomorrow, in which case I'll pull a full diagnostic and post it. Could a cabling issue occur only in v6? I haven't had this type of errors in v5.0.5 at all.
Archived
This topic is now archived and is closed to further replies.