I have noticed the past couple months, the parity check has not run for me as listed in the scheduler.  I actually can't confirm it has ever worked since upgrading to V6.  It does seem for one reason or another i have ended up with a parity check running mid month.  Woudl that stop the following scheduled parity check?  If not any ideas?

 

Attached is a snapshot of the last parity check marker, and the scheduler page.  Uploaded is my syslog.

 

todd-svr-syslog-20160209-2322.zip

Any help on this?

2nd bump, still looking for some help. 

There was a version of 6 where scheduled checks didn't work until you went into the scheduler, changed a value, then reset it back, and then applied the changes.

 

There was a version of 6 where scheduled checks didn't work until you went into the scheduler, changed a value, then reset it back, and then applied the changes.

 

Thanks, I'll give it a shot.  It may be a few days day but I'll report back. 

ok so i scheduled one to run late last night and it ran fine.. i'll go back to the first of the month and see what it does.

 

Thanks for the help. I consider it closed unless it fails to run again.