[SOLVED]: Force unRAID 6.1.9 to use eth1 rather than eth0

ashaneil

By ashaneil
in General Support

Recommended Posts

ashaneil Apprentice

ashaneil

Posted
Posted

Hi,

I used to run unRAID 5.0.2 as a VM. I have done a clean install to 6.1.9 but when I start unRAID, it defaults to using eth0 as the NIC. eth1 is available but it will not use it. The only reason why I want to use eth1 is that I do not want to crawl behind the rack and then try to wire eth0. Any suggestions?

 

 

Update:

I just re-wired eth0 [had to do it because wife wanted to watch a movie. doh!]

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
Go to topic listing