December 16, 200916 yr Hi, Cannot figure this out, pretty strange. I am using unRaid 4.5. I start to copy files to unRaid and it might run fine for a couple minutes, then it starts denying access, once it popped up some type of not enough memory error. I can re-boot unraid and some files will copy, then the error again. There is plenty of space in the array so I have no clue. Share is just one share created, no split levels and for all drives. Hardware is an older MB with a P4 2.8GHZ, 2GB Ram. 2 Onboard Sata, 1x 4 Port PCI Sata controller. Parity and largest other Sata drives are hooked up to onboard, rest is plugged into Sata Controller, 1x Drive hooled up to onboard IDE. Don't know why it starts, then stops... suggestions? help?
December 16, 200916 yr Hi, Cannot figure this out, pretty strange. I am using unRaid 4.5. I start to copy files to unRaid and it might run fine for a couple minutes, then it starts denying access, once it popped up some type of not enough memory error. I can re-boot unraid and some files will copy, then the error again. There is plenty of space in the array so I have no clue. Share is just one share created, no split levels and for all drives. Hardware is an older MB with a P4 2.8GHZ, 2GB Ram. 2 Onboard Sata, 1x 4 Port PCI Sata controller. Parity and largest other Sata drives are hooked up to onboard, rest is plugged into Sata Controller, 1x Drive hooled up to onboard IDE. Don't know why it starts, then stops... suggestions? help? Do a couple copies were it fails and then capture a syslog. you can find directions on how to do that via the Troubleshooting section in the unRAID wiki.
December 17, 200916 yr Author I just re-did the entire server, seems to be working ok now... will see what happens after some significant data is moved there.
Archived
This topic is now archived and is closed to further replies.