March 24, 201016 yr Completed with 9 drives plus parity 8 on board 2 from pcie sil monoprice card I have another 4 ports free on a pcie installed Adaptec 1430 I'll add the syslog again in a month for level 2 Mar 24 05:05:21 Tower kernel: md: sync done. time=29401sec rate=66443K/sec Mar 24 05:05:21 Tower kernel: md: recovery thread sync completion status: 0 2TB Hitachi parity with a 8.08 TB array There a few errors from my missing UPS. I didn't spot anything out of the ordinary. If you spot anything please let me know. I haven't had a chance to work on WOL so can't say if it works or not. I'll address both once I get a replacement APC UPS. cheers db syslog-2010-03-24.zip
March 28, 201016 yr Author thats the HPA bullshit I don't think so. I recently swapped my motherboard so all the drives were previouly formated and part of a array (asus). The sizes reported are consistant with my old motherboard. HPA was disabled on the new MB (Gigabyte) before I started the swap My array is basically all 1TB drives so it should report as "976,762,552" or am I misinformed here?
March 28, 201016 yr fromw hat i understand pretty much every hdd in teh last 10 yeras will end at 552 bytes.
March 29, 201016 yr Completed with 9 drives plus parity 8 on board 2 from pcie sil monoprice card I have another 4 ports free on a pcie installed Adaptec 1430 I'll add the syslog again in a month for level 2 Mar 24 05:05:21 Tower kernel: md: sync done. time=29401sec rate=66443K/sec Mar 24 05:05:21 Tower kernel: md: recovery thread sync completion status: 0 2TB Hitachi parity with a 8.08 TB array There a few errors from my missing UPS. I didn't spot anything out of the ordinary. If you spot anything please let me know. I haven't had a chance to work on WOL so can't say if it works or not. I'll address both once I get a replacement APC UPS. cheers db Finally got this added to the Hardware Compatibility Page. It took me a while (been busy looking for a house) but everything looks good. If/When you get to level 2 let me know by updating this thread and sending me a PM.
Archived
This topic is now archived and is closed to further replies.