My server is now not loading the GUI. I managed to download diagnostics before clicking to take the array offline, but that prompted the GUI to fail loading so I don't know if the array is online or offline at this point. Is there a way to tell from the command line? I am logged into the server I just can't load the GUI. I just accessed shares, so I assume the array is still online. I've attached my diagnostics. This all started when my Sonarr docker wouldn't load properly. I then tried restarting it, shutting it down, all of which lead to prolonged browser loads and then back to the docker page and it was still running. Diags attached.

tower-diagnostics-20170411-2158.zip

8 hours ago, ashman70 said:

so I don't know if the array is online or offline at this point. Is there a way to tell from the command line?

ls /mnt/

 

Should be no folders within it if the array is offline

 

Some strange network settings which may or may not explain your problems

Apr 10 20:50:59 Tower root: Fix Common Problems: Error: Unable to communicate with GitHub.com

(could possibly be your gateway address)

/boot/config/network.cfg

GATEWAY="192.168.111.20"

 While not impossible (especially, if you are running a pfSense VM / box, usually its set to the IP of your router.

Also strange that you've got 2 DNS servers on your local network.

DNS_SERVER1="192.168.111.224"
DNS_SERVER2="192.168.111.225"

with a backup to google's DNS service

All those network settings are correct. I don't know what was wrong with the box, it became unresponsive and I guess I got impatient and I hard reset it. It came up ok and I canceled the parity check but the Sonarr was doing weird things again although I finally think I got it to calm down and behave. Very strange. I am not running a pfsense box btw.

Is there a way to unmount the array from the command line?

Here you go ash

 

http://lime-technology.com/wiki/index.php/Console#To_cleanly_Stop_the_array_from_the_command_line