December 28, 20178 yr I pulled out all of the sata cables in my 6 drive machine in order to use the machine to test something unrelated to Unraid, now I am going to plug in the Unraid USB stick again and I can't remember what sata cable went to which port on the m/board... All of my hard drives are the same make & model.. Is there anyway to determine which drive was the 1x parity drive previously, so that I can just get back to where I was when I boot up Unraid again? Perhaps I can look at the drive outside of Unraid to determine if the contents show a parity drive? Thanks in advance
December 28, 20178 yr Community Expert 6 minutes ago, shimlapinks said: I pulled out all of the sata cables in my 6 drive machine in order to use the machine to test something unrelated to Unraid, now I am going to plug in the Unraid USB stick again and I can't remember what sata cable went to which port on the m/board... It doesn't matter, devices are tracked by serial number.
Archived
This topic is now archived and is closed to further replies.