chrishorton7 Posted February 1, 2018 Share Posted February 1, 2018 (edited) Hi, I have been using Unraid for a few years now and everything has been fine. Today I did some upgrades to my server: Upgrade RAM Swapped a data drive for a larger one Added a SSD which I intend to use as cache drive Did all the hardware and then booted. Everything seemed as usual and it got to the blue Unraid OS screen. It then seems to load as normal but seems to be stuck. The last message is: tower login: md: unraid driver 2.9.3 installed It seems to be hanging from there. Have left for a while and no movement. Any ideas? Edited February 1, 2018 by chrishorton7 Quote Link to comment
SiNtEnEl Posted February 1, 2018 Share Posted February 1, 2018 (edited) I would do a Memtest, and check if the memory is working correctly. If that doesnt work, disconnect the new drives and try a Memtest. Proceed from that if it's ok. Edited February 1, 2018 by SiNtEnEl Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Should have added when I swapped the memory out I started Unraid fine to confirm all was ok and it was. I then shut down to change and add the drive Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Happy to run a memtest though, how long does it take to run? Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Ok running memtest now. When you say disconnected new drives. I assume you mean just the new data drive and SSD drive rather than all of them? Or should I try it with no drives connected to see if I can at least get the OS to boot? Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Just a thought, I noticed that while running the memtest that my server 'tower' isn't showing in my attached devices list for my router. At what point would it connect? Only once the OS is fully loaded? Quote Link to comment
SiNtEnEl Posted February 1, 2018 Share Posted February 1, 2018 Memtest cycle can run a while, if its running a memtest it won't show up in the network. If memtest is OK, boot the OS with out the new disks see if its OK. Then add the disks one for one. (offline and then see if it boots) Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Ok so memtest completed all fine. I tried a quick boot before I start unplugging the drives and it seemed to get a little further before hanging. I now see the following message: Tower login: md: unRAID driver 2.9.3 installed mdcmd (1): import 0 md: import_slot: 0 missing Not sure if that gives any more clues before I start unplugging the drives individually? Quote Link to comment
chrishorton7 Posted February 1, 2018 Author Share Posted February 1, 2018 Ok managed to solve it. For some reason it didnt like my SSD being plugged into the sata add on card. Moved it to sata port on the motherboard and now booting ok. Thanks for the speedy help SiNtEnEl Quote Link to comment
SiNtEnEl Posted February 1, 2018 Share Posted February 1, 2018 Glad you found the issue, well at least u confirmed the memory is OK. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.