February 1, 20188 yr Hi folks, big problems with the S3 Sleep plugin: Since v6.4.0 the plugin ignores almost all settings. All was working well under 6.3.5 but since 6.4.0 the server went to sleep although disks are running and i cant prevent this. I tried to enlarge the extra delay time but no luck - server goes to sleep even disks are running - not good. Whats up now? Any hints? Is this behavior already known? Thans in advance Edited February 1, 20188 yr by Zonediver
February 1, 20188 yr Author 5 minutes ago, johnnie.black said: It's a known issue: ...shit... i almost suspected... Ok, thanks for this info. Shall i revert to 6.3.5. or is there a proper patch in work? Edited February 1, 20188 yr by Zonediver
February 2, 20188 yr As a temporary workaround you can disable the check on disk activity and use another activity to check, e.g. network or IP address. Or disable S3 completely (no action). When time permits I'll look for a correction.
February 2, 20188 yr Author 3 hours ago, bonienl said: As a temporary workaround you can disable the check on disk activity and use another activity to check, e.g. network or IP address. Or disable S3 completely (no action). When time permits I'll look for a correction. I will try to check if the setting with the network traffic work for me - thanks for this info. The other options (IP and disable) are useless for me because most of the time i contact my server from outside the LAN.
February 3, 20188 yr Author As i expected this setting with network idle doesnt work. It didnt work under v5 and it doesnt work under v6. It doesnt matter what value i use (low or high), server doesnt go to sleep... At idle, the network traffic is between 12 and 16kbit/s - so what is the correct setting to put the server into sleep? Edited February 3, 20188 yr by Zonediver
Archived
This topic is now archived and is closed to further replies.