ygortower02-syslog-20180417-1619.zip

After successful flashing unraid don't see any drive

What makes you think no drives are being seen?   According to the syslog 6 drives are being seen.

6 are on motherboard  8 are on h310 (500gb drive)

Wrong type of cable?  Reverse vs Forward breakout?

was working with aoc controller but was unstable same connector

Are the connectors mating properly with the ones on the card? I found them to be particularly tight on my H310s.

Mating good not tight 

Apr 17 18:17:21 YgorTower02 kernel: mpt2sas_cm0: LSISAS2008: FWVersion(20.00.07.00), ChipRevision(0x03), BiosVersion(00.00.00.00)

see the controller with good firmware but no drive on the controller

I'd re-flash it and include a BIOS. Then see if the card detects the disks at POST.

 

Here's what I see:

Apr 10 12:46:28 Mandaue kernel: mpt2sas_cm0: LSISAS2008: FWVersion(20.00.07.00), ChipRevision(0x03), BiosVersion(07.39.02.00)

 

Ok will try That just to be shure what is the bios to be

 

2 minutes ago, John_M said:

BiosVersion(07.39.02.00)

 

is what I'm using

Apr 17 20:50:33 YgorTower02 kernel: mpt2sas_cm0: LSISAS2008: FWVersion(20.00.07.00), ChipRevision(0x03), BiosVersion(07.39.02.00)

now i have the bios loaded but No unassigned disks available ??
 

ygortower02-syslog-20180417-2051.zip

Edited April 18, 20188 yr by ygor

OK install 2 used hard disk and it see them but not the 6 hitachi hds725050kla360, what is the problem with those drive, can they be flash ??ygortower02-syslog-20180417-2135.zipygortower02-syslog-20180417-2135.zip

I think is SATA 1.5Gb/s not compatible with dell h310 can someone confirm that statement.

Thank You!

I remember having read about a similar problem in this forum.

IIRC it was indeed a bad configured disk.

I will do some research and see if I can find the post again.

 

Edit:

I'm sorry, but I can't find the related post.

I don't think the controller is not compatible with SATA I specification.

In fact, the drives you mention are SATA II according to the data sheet.

https://www.hgst.com/sites/default/files/resources/Deskstar_E7K500_DS.pdf

 

Are there any jumpers on the drives?

I remember the solution in that mentioned post referred to a wrong jumper setting.

Edited April 18, 20188 yr by Fireball3

Ok those drive were set to sata 1.5 gbs, after setting to sata 3 gbs all went well, all 8 500gb drive was present have to write the setting with http://files.hddguru.com/download/Software/HITACHI DRIVE FEATURE TOOL/?order=mod&direction=1

Thanks for your help!