[unRAID 6.5.x] USB Port not working after Reboot


Recommended Posts

Hello everyone,

 

first off my specs:

  • unRAID 6.5.2 (but problem exists since I installed unRAID 6.5.0)
  • M/B: ASRockRack - C236 WSI
  • CPU: Intel® Pentium® CPU G4600 @ 3.60GHz
  • HVM: Enabled
  • IOMMU: Enabled
  • Cache: 128 kB, 512 kB, 3072 kB
  • Memory: 16 GB Single-bit ECC (max. installable capacity 32 GB)
  • Chassis: DS380 w/ Cardboard Hack
  • USB Stick: Intenso Slim Line 16 GB

 

The chassis has two front panel USB connectors.

 

The problem:

After reboot, I have to switch from one USB port to the 2nd. Otherwise the stick won't register.

If I reboot again, I have to switch back to the first USB port (so I ruled out a hardware defect) otherwise boot to BIOS.

Rinse and repeat.

 

It was a minor inconvenience, since the server is sitting under my desk UNTIL I was at a  LAN Party, where the server area was located in another building.

I was running more in 2 days, than in that whole week, since I had to troubleshoot the server but could not ssh into it. A total nightmare.

 

So I am turning to you :)  Any ideas, what this is and how it is caused?

 

Thanks for reading, have a nice day :)

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.