May 28, 20188 yr Howdy folks I've just had a pending sector count error on one of my drives. I replaced it and started the array and it appeared to be rebuilding just fine. It finished after a few minutes which seemed too quick for 2.84TB, but now the brand new disk is disabled and I have error warnings... The disk settings page hangs and won't show any SMART data. Is the new drive DOA? Can I just put a new one in and start the rebuild again? Logs attached ErrorWarningSystemArrayLogin.pdf
May 28, 20188 yr Community Expert Please post your diagnostics, before and after rebooting: Tools -> Diagnostics
May 28, 20188 yr Author done myserver-diagnostics-20180528-1257.zip myserver-diagnostics-20180528-1250.zip
May 28, 20188 yr Community Expert Disk3 is still offline after rebooting, power down, check connections and try again, if still not detected it may be dead.
May 28, 20188 yr Author Thank you. Drive reseated and rebuild running into 2nd hour now. What seemed odd is that the drive was assigned before the first rebuild attempt... It then showed 'disabled' rather than offline leading me to think unRaid had disabled it but I couldn't figure out why...
Archived
This topic is now archived and is closed to further replies.