August 21, 201015 yr I'm using unRAID 5.0 beta 2. I'm going through the steps of adding a new drive to the unRAID array. I'm letting emhttp do the clearing for me. What I see in the management console is simply: Start array... However, in the log files I see the following. Aug 21 18:01:03 reavers emhttp: writing mbr on disk 3 (/dev/sde) Aug 21 18:01:03 reavers emhttp: re-reading /dev/sde partition table Aug 21 18:01:03 reavers kernel: sde: sde1 Aug 21 18:01:04 reavers emhttp: clearing disk3 ... Aug 21 18:04:13 reavers emhttp: ... clearing 1% complete Aug 21 18:07:27 reavers emhttp: ... clearing 2% complete Aug 21 18:10:40 reavers emhttp: ... clearing 3% complete Aug 21 18:13:54 reavers emhttp: ... clearing 4% complete Aug 21 18:17:07 reavers emhttp: ... clearing 5% complete Aug 21 18:20:21 reavers emhttp: ... clearing 6% complete Aug 21 18:23:34 reavers emhttp: ... clearing 7% complete Aug 21 18:26:48 reavers emhttp: ... clearing 8% complete Aug 21 18:30:02 reavers emhttp: ... clearing 9% complete Aug 21 18:33:20 reavers emhttp: ... clearing 10% complete Can we get those messages displayed to the console?
August 28, 201015 yr Also in beta 2, I tried adding two new disks to an array at the same time, the console never cleared either one of them. I had to remove one and add them to the array one at a time
August 29, 201015 yr Happened to me too, but I had pre-cleared the drives... I think it locked up when formatting them. ( I think it was on beta-1. )
Archived
This topic is now archived and is closed to further replies.