September 20, 20187 yr Hi All, I need a basic clarification on the following. I have a Dell H200 on a R710. The H200 is currently with the IR firmware, and I'm trying to cross-flash it to IT mode. After the cross-flashing I can verify that it's indeed cross-flashed with the correct IT firmware. I was wondering from Unraid's standpoint is there a way to distinguish the following two scenarios: a single hard drive in RAID 0 exposed as a single virtual drive or the same single hard drive in the IT mode exposed to Unraid. In addition to the checking the firmware version, I was thinking of verifying this from the OS standpoint also. Any ideas? Thanks.
September 20, 20187 yr 6 minutes ago, sibi78 said: Hi All, I need a basic clarification on the following. I have a Dell H200 on a R710. The H200 is currently with the IR firmware, and I'm trying to cross-flash it to IT mode. After the cross-flashing I can verify that it's indeed cross-flashed with the correct IT firmware. I was wondering from Unraid's standpoint is there a way to distinguish the following two scenarios: a single hard drive in RAID 0 exposed as a single virtual drive or the same single hard drive in the IT mode exposed to Unraid. In addition to the checking the firmware version, I was thinking of verifying this from the OS standpoint also. Any ideas? Thanks. Most likely the lack of SMART for the RAID config. Even JBOD non-IT usually doesn't send SMART data downstream.
September 22, 20187 yr I think on mine when I changed the card, the drives now show the model/serial in the Unraid interface using JBOD. In Raid0, they showed a generic name (provided by the raid card).
Archived
This topic is now archived and is closed to further replies.