Disk 2 started showing high reallocated sector counts so I replaced it with a new drive. A few hours into the disk 2 data rebuild, disk 3 started showing high reallocated sector counts. The rebuild process is now taking forever and I'm worried another drive might fail over the long rebuild. Is there a better way to proceed? Or should I just let it continue. Not sure what to do.

 

Thanks!

filesvr-diagnostics-20181026-0816.zip

Good you already have dual parity, if the rebuild is still going slow, cancel, it, replace disk3 with a new one and rebuild both at the same time.

Ok. I do have another drive ready, so I think I'll go ahead with your suggestion. Especially if it speeds up the rebuild process.

 

Thanks so much!