I just recently got this on my server 'irq 16: nobody cared"

I did notice performance of the parity check was way down, then I found this. I didn't know if this had anything to do with the other, or not.

 

Thanks for all the help

 

Diagnostics belowmediaserver1-syslog-20181112-1138.zip

SAS2LP usually uses IRQ16, so if it got disable performance will crash, until a reboot, though you should replace it with an LSI anyway since they have several known issues.

44 minutes ago, johnnie.black said:

SAS2LP usually uses IRQ16, so if it got disable performance will crash, until a reboot, though you should replace it with an LSI anyway since they have several known issues.

Seems odd that it would just begin now after a few years of great performance, but I will reboot to see any changes. As far as LSI, Disabled Vet with Fixed income says no...lol

Rebooted and all seems fine at this point, will check performance over the next few days,  

thanks loads

13 minutes ago, icedragonslair said:

Seems odd that it would just begin now after a few years of great performance,

This is typical, some of the issues with the SAS2LP can pop up at any time after years of trouble free use, most likely to happen after a hardware or software change, like an Unraid update.

I have run into a similar problem with my old system in the past...

 

 

Never managed to find a solution for, expect for not hooking up a monitor to my rig, which worked without a hitch for about 2 years.

Changed platform (Dell T1650 motherboard and E3-1220 v2) and have not had any issues with the controller (SASLP-MV8).