Lost a drive


DJRon

Recommended Posts

Woke up to an error on my unraid this morning, 

Quote

Event: Unraid Disk 5 error
Subject: Alert [EPCOT] - Disk 5 in error state (disk dsbl)

Some back ground information. I just replaced this drive a few weeks ago after receiving this error:

Quote

active 27 C (disk has read errors) [NOK]

SMART Results
ATA Error Count: 1

CR = Command Register [HEX]

FR = Features Register [HEX]

SC = Sector Count Register [HEX]

SN = Sector Number Register [HEX]

CL = Cylinder Low Register [HEX]

CH = Cylinder High Register [HEX]

DH = Device/Head Register [HEX]

DC = Device Command Register [HEX]

ER = Error register [HEX]

ST = Status register [HEX]

 

Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days.

 

Error 1 occurred at disk power-on lifetime: 9848 hours (410 days + 8 hours)

When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH

-- -- -- -- -- -- --

40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455

So I ran diagnostics (attached). And took down the array and rebooted. I was going to start the array but noticed is had Disk 5 as unassigned. I am suspecting a problem with that specific strand  of the controller card. Not like I have extra of those sitting around. Looking for thoughts or other possibilities by people with more knowledge and experience than me.

 

I posted another topic I may be relevant to this as it was Drive 5 that seemed to be constantly spinning: 

Thanks in advance and Happy Holidays everyone.

epcot-diagnostics-20181218-0630.zip

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.