Advice on modernizing hardware & power usage - Stay with current setup or go?

[hedrinbc]

Hey all, I have a now free to me (hand me downs from other upgrades) box setup but wondering is there is value going for a more modern or low power build.

 

Everything is stable but older, I do have a backup motherboard in case of failure but no backup CPU.

 

I know the AMD is "old" and "inefficient" but the measured watts doesn't seem extremely high.

 

Any suggestions for modernizing or should I just run it?

 

_All_ the below is using ~130-~150 Watts at average (spun up, not crunching) usage measured with Kiill-a-watt.

 

• CPU: AMD FX 6300
• HDs: 4 - Two WD Reds, Intel SSD Cache Drive and a Toshiba Unassigned Drive (Docker, Temp Downloads, Etc.)
• RAM: 16GB DDR3
• Main Apps: Plex (need some transcoding but not too much, mostly directplay), Unifi, Pihole, Ubuntu VM
• UPS: APC Smart-UPS 1000 XL
• Networking: 24 Port Switch, Unifi USG, 3 Unifi APs, Vonage, Cable Modem

 

I'd appreciate any thoughts!

 

 

Edited December 26, 2018 by hedrinbc

[whipdancer]

Why not run it and decide if you need more then?

[hedrinbc]

@whipdancer fair, I guess I'm always interested in a project but not sure if this one has a return on investment.

 

Do you know if your Ryzen (I know you have a lot more disk than me so maybe spun down) idles lower than 100w?

[whipdancer]

I've never measured my setup. The CPU has a TDP of 65, so I would expect it to idle less than 100w.

Not definitive by any means, but a reasonable comparison.
https://www.guru3d.com/articles-pages/amd-ryzen-5-2600-review,7.html