Jump to content
darkcyde

Network Bonding Assistance

2 posts in this topic Last Reply

Recommended Posts

Hi

I currently have two NICs, one is a 4 port assigned completely to a VM for pfSense, and the other is an on-board 2 port for UnRaid.

 

They are currently configured as two separate ports with a unique IP, but I would like to bond them together to spread the bandwidth across both ports, but I can't seem to configure it....at some point I seem to have created two Bond groups and now each port is assigned to a Bond group of its own and I can't change this....can anyone help?

 

I've attached a screenshot of my network config page below...

 

 screenshot.bonding.thumb.jpg.fc725616e916017544e3609be83535d6.jpg

Share this post


Link to post

Remove bonding from eth1.

Then add eth1 as bond member of eth0.

 

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.