TheBlueKingLP Posted January 23, 2019 Share Posted January 23, 2019 (edited) When I try to setup link aggregation(802.3ad bond), I only get 1 selectable interface in Bonding members of bond0, how can I add my second nic? Both nics are internal nic Edited January 23, 2019 by TheBlueKingLP Quote Link to comment
bonienl Posted January 23, 2019 Share Posted January 23, 2019 Make sure eth1 is not set as bond and/or bridge. After that the interface becomes available as selection item for bond0. Quote Link to comment
TheBlueKingLP Posted January 23, 2019 Author Share Posted January 23, 2019 35 minutes ago, bonienl said: Make sure eth1 is not set as bond and/or bridge. After that the interface becomes available as selection item for bond0. I disabled bond and bridge for eth1 but still not available as selection item for bond0 Quote Link to comment
bonienl Posted January 23, 2019 Share Posted January 23, 2019 Post a screenshot of your network settings page Quote Link to comment
TheBlueKingLP Posted January 23, 2019 Author Share Posted January 23, 2019 20 minutes ago, bonienl said: Post a screenshot of your network settings page Quote Link to comment
bonienl Posted January 23, 2019 Share Posted January 23, 2019 For interface eth1 change "Enable bonding" setting to NO and apply. Then add eth1 as member to bond0 1 Quote Link to comment
TheBlueKingLP Posted January 23, 2019 Author Share Posted January 23, 2019 15 minutes ago, bonienl said: For interface eth1 change "Enable bonding" setting to NO and apply. Then add eth1 as member to bond0 oh, ok, it worked this time. sorry about that. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.