I have a Windows 10 vm that keeps going into pause mode randomly.  Just did it while typing the first sentence of this post.   I can click resume and sometimes its good for a while other times just minutes before pausing again. Libvirt log is showing errors.  Any suggestions?   Unraid 6.6.6   diagnostics attached. 

tower-diagnostics-20190124-2002.zip

Edited January 29, 20197 yr by goinsnoopin

Didn't look at diagnostics, but I'll be the drive holding the vdisk is out of space. Even if it shows free space available, it could need file system maintenance to allow that space to be used.

Cache is 99% full, and after emptying some data run a balance since it's also fully allocated, though it might not be after some space is freed:

https://lime-technology.com/forums/topic/62230-out-of-space-errors-on-cache-drive/?do=findComment&comment=610551

 

Edited January 25, 20197 yr by johnnie.black

Thanks jonathanm and johnnie.black...cache disk space was my issue.  Made some room and am all set!

 

Dan

I am having this issue too. However, I have my vdisk stored on its own drive (not the cache) and it has over 800GB free. Power settings within the VM are set to never sleep. I am also unable to resume the VM when it pauses, I must force stop and then restart the VM. Any thoughts? I am running the latest stable release, 6.7.2

Edited December 4, 20196 yr by danielcook1996

Please post the diagnostics 

On 2019/12/4 at PM2点03分, danielcook1996 said:

我也有这个问题。但是，我的虚拟磁盘存储在其自己的驱动器（而不是缓存）上，并且有超过800GB的可用空间。VM中的电源设置设置为永不休眠。暂停时，我也无法恢复虚拟机，必须强制停止然后重新启动虚拟机。有什么想法吗？我正在运行最新的稳定版本6.7.2

I have the same problem as you. Have you solved your problem?