I had an issue where a port on my MB went bad causing my cache to come up as bad BTRFS. Since I had recently been given a better system anyway I decided it would be best to just move everything over. 

I have done that and the system boots. Unfortunately it is saying every drive is "wrong" 

Apparently the new system is using an _ in the drive name where the old used a 0. I'm unsure how or why but this obviously is preventing the array from starting. 
any help would be greatly appreciated.

 

Thank you,

Edited February 3, 20197 yr by elbobo

Hopefully you made a screenshot or wrote down which drive was in which disk slot. If so I believe you will need to do a new config and re-assign the drives to the same slots. This happened to me when I changed controller cards as the new card reported much shorter names for the drives then the original card.

Yeah, as I have them right now is accurate (the last 10 digits didn't change) 

What do I have to do to do a new config? Right now it is telling me my config has too many wrong and will not let me assign anything to any slots. 

 

Tools -> New Config

 

Sorry I should have looked there first.

 

Parity is being rebuilt 

 

Thank you