axeman Posted March 17, 2019 Share Posted March 17, 2019 I had a failed drive that I was planning on pulling out and swapping in a new drive. I stopped the array, and powered down my drive chasis. This was probably stupid. As I did that, Unraid started throwing a bunch of errors about drives going missing. So I did a clean shutdown. After that, I powered the chasis back up, then powered UnRaid on. Upon first boot, Unraid is asking me for a NEW encryption key. At the bottom, it says Stale Config. I want to proceed carefully. The drive that was pulled is still available. What's the safest way to proceed? Quote Link to comment
axeman Posted March 17, 2019 Author Share Posted March 17, 2019 I put the disk to be replaced back in... and powered everything on again... This time, i got valid configuration, and prompt to enter encryption key. Quote Link to comment
axeman Posted March 18, 2019 Author Share Posted March 18, 2019 Mods - you can delete this. I tried, but can't seem to. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.