May 10, 20197 yr I replaced an old 2TB HDD with a brand new 10TB one. The rebuilding process was going along smoothly until about halfway through (4.8TB) I got an error. Now the read check in progress is paused. I think it's unlikely the drive is bad and cable issues are more likely, but then it probably would have failed earlier right? I can't make heads or tails of the log so I was hoping some of the more experienced members might shed some light on how to proceed. I still have th 2TB drive, but I don't know if I can just plug it right back in, since parity has certainly changed (the server was still in use during that time, which may have been a mistake). Any insight I'd appreciate it. tower-diagnostics-20190510-1919.zip
May 11, 20197 yr Community Expert Looks more like the typical SASLP problem, i.e., dropping disks for no reason, but since the disk dropped there's no SMART, so reboot/power cycle and if the disk comes online post new diags.
Archived
This topic is now archived and is closed to further replies.