July 24, 20196 yr Hello All, I'm running into a problem when setting up WOL in UnRaid - it works if I use Windows 10 instead so the settings should be set right but I can't get it to work in UnRaid, it almost seems like UnRaid turns off the network port always - in sleep and shutdown. Some strange findings I found: If i run below command through the terminal I can't put the machine to sleep, it tries to sleep but instantly wakes up ethtool -s eth0 wol g If I run the same command through telnet I can succesfully put it to sleep and wake it up using WOL -> only works once though, can't put it to sleep again, it will try to go to sleep but instantly wakes up again -> I have to reboot first and rerun the command Output of `ethtool eth0`: Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Link partner advertised pause frame use: Symmetric Link partner advertised auto-negotiation: Yes Link partner advertised FEC modes: Not reported Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) drv probe ifdown ifup Link detected: yes Also something else weird I noticed -> when I run `ethtool -s eth0 wol pumbg` it's set but only for the current session -> so after reboot it's gone, not persisting The Ethernet chip is the: RTL8111E chip Can someone please help?
Archived
This topic is now archived and is closed to further replies.