ThaDaVos Posted July 24, 2019 Share Posted July 24, 2019 Hello All, I'm running into a problem when setting up WOL in UnRaid - it works if I use Windows 10 instead so the settings should be set right but I can't get it to work in UnRaid, it almost seems like UnRaid turns off the network port always - in sleep and shutdown. Some strange findings I found: If i run below command through the terminal I can't put the machine to sleep, it tries to sleep but instantly wakes up ethtool -s eth0 wol g If I run the same command through telnet I can succesfully put it to sleep and wake it up using WOL -> only works once though, can't put it to sleep again, it will try to go to sleep but instantly wakes up again -> I have to reboot first and rerun the command Output of `ethtool eth0`: Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Link partner advertised pause frame use: Symmetric Link partner advertised auto-negotiation: Yes Link partner advertised FEC modes: Not reported Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) drv probe ifdown ifup Link detected: yes Also something else weird I noticed -> when I run `ethtool -s eth0 wol pumbg` it's set but only for the current session -> so after reboot it's gone, not persisting The Ethernet chip is the: RTL8111E chip Can someone please help? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.