JCristina Posted August 8, 2019 Share Posted August 8, 2019 (edited) I'm not sure if this has to do with the latest UPDATE but here's the issue. When hot swapping a drive in the past; the drive would immediately show up as an Unassigned_Devices and now, they don't! I've tried the following: Plugged drives into all the available bays, nothing. Deleted Unassigned_Devices and Reinstalled, nothing. The only thing that works is to [ REBOOT ] the server. As you can see a before and after screenshot. Before, the reboot, NO DRIVE, after the REBOOT the drive miraculously appears ready to be MOUNTED. Any help would be greatly appreciated! Edited August 8, 2019 by JCristina Uploaded wrong AFTER screenshot. Quote Link to comment
testdasi Posted August 8, 2019 Share Posted August 8, 2019 Try this in console rescan-scsi-bus Quote Link to comment
JCristina Posted August 8, 2019 Author Share Posted August 8, 2019 Thank you. I will give that a shot and report back. I wonder what is the cause of the issue. Quote Link to comment
JCristina Posted August 9, 2019 Author Share Posted August 9, 2019 Thanks testdasi! Worked! Screencaps attached. 1. 4th drive installed and does not show up 2. 4th drive installed and rescan-scsi-bus was executed. 3. 4th now shows up as an Unassigned_Device Question for everyone... This was not a "THING" prior to the update. Is this a bug that needs to be worked out or are we just going to have to re-scan the drive each time we hotswap a drive? Thanks all! Quote Link to comment
dlandon Posted August 9, 2019 Share Posted August 9, 2019 Try clicking the double arrows next to the complete switch at the top of the UD page. This should rescan for devices. Do you have hot swap enabled in the bios? Quote Link to comment
JCristina Posted August 9, 2019 Author Share Posted August 9, 2019 Thanks for the double arrow rescan tip. As for the mother board, yes. It’s set for hot swap and nothing has changed since the stable 6.7.2 update. It’s a brand new install with no data on the main 16TB of drive. Quote Link to comment
JCristina Posted August 9, 2019 Author Share Posted August 9, 2019 17 hours ago, dlandon said: Try clicking the double arrows next to the complete switch at the top of the UD page. This should rescan for devices. Do you have hot swap enabled in the bios? Nope! The rescan button does not work. Still the command line or reboot is the only remedy. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.