Hello, I've been running 5.06 for a while and I tried Upgrading my usb drive to 6 and also starting fresh and it doesn't seem to go past this stage show in picture.

 

I have 4 HDD's in the bays, 2 HDD's via SATA card and a Cache drive.

Have you tried preparing the flash again? Did you follow the Upgrade Guide in the wiki?

 

https://wiki.unraid.net/Upgrading_to_UnRAID_v6

I've tried many times.

I've tried a fresh install and also an upgrade from my 5.06.

If I delete 6 from usb drive and copy the 5.06 contents back the HP boots fine.

How much RAM do you have?

1Gb which is the minimum requirement.

 

 

* 

I just copied back my back up of 5.06 and it works fine.

Edited September 5, 20196 yr by ChooChee

49 minutes ago, ChooChee said:

1Gb which is the minimum requirement.

Have you done a memtest?

 

I'm not sure many (if any) people are running V6 with that little RAM. Can you add any?

 

I am not sure that the current version of Unraid can even run in 1GB.     It is known that you can run in 2GB but that with that little RAM certain operations (e.g. online upgrades of releases) are likely to fail.    This means that 4GB RAM is about the minimum that is now recommended for stable running.

I've got 2 x 2gb non ecc Samsung sticks I can try. If that works, I'll pick up 2x4gb ecc Kingston's. 

I forgot that there was already a Samsung 1gb non ecc stick in there, so I replaced that with 2x2gb Samsung non ecc sticks and it's good to go. Thanks guys for the assistance!!