September 9, 20196 yr Noticed that the parity drive has disabled, The SMART info has ;- "exiting. To continue, add one or more '-T permissive' options." In terminal, smartctl -T permissive -s on /dev/sdd smartctl 7.0 2018-12-30 r4883 [x86_64-linux-4.19.56-Unraid] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org Short INQUIRY response, skip product id === START OF ENABLE/DISABLE COMMANDS SECTION === unable to fetch IEC (SMART) mode page [scsi response fails sanity test] A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options. smartctl -T permissive -a /dev/sdd smartctl 7.0 2018-12-30 r4883 [x86_64-linux-4.19.56-Unraid] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org Short INQUIRY response, skip product id === START OF READ SMART DATA SECTION === SMART Health Status: OK Current Drive Temperature: 0 C Drive Trip Temperature: 0 C Read defect list: asked for grown list but didn't get it Error Counter logging not supported Device does not support Self Test logging It's a WD RED 3TB -probably 3years old, and before I noticed the problem, the normally quiet server was clunking a bit. Is it likely that the disk has gone and "run up the curtain and joined the choir eternal"?
September 10, 20196 yr Community Expert That suggests the disk dropped offline, reboot/power cycle and post new diags, but also save and post the ones before rebooting.
Archived
This topic is now archived and is closed to further replies.