io1901 Posted September 9, 2019 Share Posted September 9, 2019 Noticed that the parity drive has disabled, The SMART info has ;- "exiting. To continue, add one or more '-T permissive' options." In terminal, smartctl -T permissive -s on /dev/sdd smartctl 7.0 2018-12-30 r4883 [x86_64-linux-4.19.56-Unraid] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org Short INQUIRY response, skip product id === START OF ENABLE/DISABLE COMMANDS SECTION === unable to fetch IEC (SMART) mode page [scsi response fails sanity test] A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options. smartctl -T permissive -a /dev/sdd smartctl 7.0 2018-12-30 r4883 [x86_64-linux-4.19.56-Unraid] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org Short INQUIRY response, skip product id === START OF READ SMART DATA SECTION === SMART Health Status: OK Current Drive Temperature: 0 C Drive Trip Temperature: 0 C Read defect list: asked for grown list but didn't get it Error Counter logging not supported Device does not support Self Test logging It's a WD RED 3TB -probably 3years old, and before I noticed the problem, the normally quiet server was clunking a bit. Is it likely that the disk has gone and "run up the curtain and joined the choir eternal"? Quote Link to comment
JorgeB Posted September 10, 2019 Share Posted September 10, 2019 That suggests the disk dropped offline, reboot/power cycle and post new diags, but also save and post the ones before rebooting. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.