October 5, 20196 yr I changed ISPs and installed a new router (Ubiquity Edgerouter X), and upon boot I found that //Tower no longer resolves to my 6.7.2 server. "ifconfig eth0" didn't give me an IPv4 address as per the configuration tutorial and I'm not sure where to go next. I attached the diagnostics log if that's needed. Hardware: Ryzen 3 2200G ASRock A320 M-ITX Thanks for any help. tower-diagnostics-20191004-2341.zip Edited October 5, 20196 yr by MM23
October 5, 20196 yr Community Expert It looks like you have a networking problem. The is no evidence that you are connected to anything from the diagnostics. Change Cat5 cable between server and router/switch. Do the lights on the router/switch and the server indicate that you have a good connection? Switch to a different port if connected directly to the router. Did you setup your ER-X correctly? (My ER-X was NOT a simple plug-and-play install! If you need help in this area, I can point you to an excellent tutorial for the beginner.)
October 5, 20196 yr Author Woops! Seems the eth2 port on the Edgerouter was not working. I switched over to eth3 and we are online now. Thanks for the assistance.
October 5, 20196 yr Community Expert Personally, I am a firm believer that you should always have only a switch plugged into a router. Using inexpensive routers as a switch has two side issues. First, it causes the router to run hot and, second, it will usually have performances issues especially if you have fast Internet service. Right now, I can't understand why port2 is 'not working' unless the router is bad or misconfigured. (You do know that the ER-X is a prosumer router and is very powerful beast device but it has a bit of a learning curve. You can get the tutorial I was referring to here:) https://github.com/mjp66/Ubiquiti/blob/master/Ubiquiti Home Network.pdf
Archived
This topic is now archived and is closed to further replies.