pmiller1673 Posted November 9, 2019 Share Posted November 9, 2019 (edited) My server was up and running then my internet crashed. I ended up having to switch my router to the stock modem/router all in one (I have Starry for ISP if that matters at all). Ever since I have been getting this on boot: IPv4 address: not set IPv4 address: not set I saw another thread saying to change BONDING to NO in the network.cfg file. This didn't appear to change anything. I tried recreating the boot USB to start fresh and nothing changed either. I'm not concerned with saving any data as all I had was a few dockers installed, this is a new NAS build. I'm not sure what to do from here and any help is appreciated! I attached the diagnostics file from the most recent boot. tower-diagnostics-20191109-0726.zip Edited November 9, 2019 by pmiller1673 Quote Link to comment
trurl Posted November 9, 2019 Share Posted November 9, 2019 Check cables and connections including plugs and ports. Quote Link to comment
pmiller1673 Posted November 9, 2019 Author Share Posted November 9, 2019 Tried that, still nothing. Swapped the cords and ports with my desktop and they work just fine there. Quote Link to comment
bonienl Posted November 9, 2019 Share Posted November 9, 2019 Your diagnostics show that the interface is not connected. Settings for eth0: Supported ports: [ TP AUI BNC MII FIBRE ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: Unknown! Duplex: Unknown! (255) Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) drv probe ifdown ifup Link detected: no Usually this is a cable problem. Quote Link to comment
pmiller1673 Posted November 9, 2019 Author Share Posted November 9, 2019 I feel like an ninny but i got it to work. Pulled ethernet cables from everything and used compressed air on all ports. Works now! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.